NAME

    Device::Chip::BME280 - chip driver for BME280

SYNOPSIS

       use Device::Chip::BME280;
       use Future::AsyncAwait;
    
       my $chip = Device::Chip::BME280->new;
       await $chip->mount( Device::Chip::Adapter::...->new );
    
       await $chip->change_config(
          OSRS_H => 4,
          OSRS_P => 4,
          OSRS_T => 4,
          MODE   => "NORMAL",
       );
    
       my ( $pressure, $temperature, $humidity ) = await $chip->read_sensor;
    
       printf "Temperature=%.2fC  ", $temperature;
       printf "Pressure=%dPa  ", $pressure;
       printf "Humidity=%.2f%%\n", $humidity;

DESCRIPTION

    This Device::Chip subclass provides specific communication to a Bosch
    BME280 attached to a computer via an I�C adapter.

    The reader is presumed to be familiar with the general operation of
    this chip; the documentation here will not attempt to explain or define
    chip-specific concepts or features, only the use of this module to
    access them.

METHODS

    The following methods documented in an await expression return Future
    instances.

 read_id

       $id = await $chip->read_id

    Returns the chip ID.

 read_config

       $config = await $chip->read_config

    Returns a HASH reference containing the chip config, using fields named
    from the data sheet.

       FILTER   => OFF | 2 | 4 | 8 | 16
       MODE     => SLEEP | FORCED | NORMAL
       OSRS_H   => SKIP | 1 | 2 | 4 | 8 | 16
       OSRS_P   => SKIP | 1 | 2 | 4 | 8 | 16
       OSRS_T   => SKIP | 1 | 2 | 4 | 8 | 16
       SPI3W_EN => 0 | 1
       T_SB     => 0.5 | 10 | 20 | 62.5 | 125 | 250 | 500 | 1000

 change_config

       await $chip->change_config( %changes )

    Writes updates to the configuration registers.

    Note that these two methods use a cache of configuration bytes to make
    subsequent modifications more efficient.

 read_status

       $status = await $chip->read_status;

 read_raw

       ( $adc_P, $adc_T, $adc_H ) = await $chip->read_raw

    Returns three integers containing the raw ADC reading values from the
    sensor.

    This method is mostly for testing or internal purposes only. For
    converted sensor readings in real-world units you want to use
    "read_sensor".

 read_sensor

       ( $pressure, $temperature, $humidity ) = await $chip->read_sensor

    Returns the sensor readings appropriately converted into units of
    Pascals for pressure, degrees Celcius for temperature, and percentage
    relative for humidity.

AUTHOR

    Paul Evans <leonerd@leonerd.org.uk>