patch-2.4.7 linux/drivers/message/fusion/lsi/fc_log.h

• Lines: 84
• Date: Fri Jul 6 17:03:11 2001
• Orig file: v2.4.6/linux/drivers/message/fusion/lsi/fc_log.h
• Orig date: Wed Dec 31 16:00:00 1969

diff -u --recursive --new-file v2.4.6/linux/drivers/message/fusion/lsi/fc_log.h linux/drivers/message/fusion/lsi/fc_log.h
@@ -0,0 +1,83 @@
+/*
+ *  Copyright (c) 2000-2001 LSI Logic Corporation. All rights reserved.
+ *
+ *  NAME:           fc_log.h
+ *  SUMMARY:        MPI IocLogInfo definitions for the SYMFC9xx chips
+ *  DESCRIPTION:    Contains the enumerated list of values that may be returned
+ *                  in the IOCLogInfo field of a MPI Default Reply Message.
+ *
+ *  CREATION DATE:  6/02/2000
+ *  ID:             $Id: fc_log.h,v 4.2 2001/03/01 18:28:59 fibre Exp $
+ */
+
+
+/*
+ * MpiIocLogInfo_t enum
+ *
+ * These 32 bit values are used in the IOCLogInfo field of the MPI reply
+ * messages.
+ * The value is 0xabcccccc where
+ *          a = The type of log info as per the MPI spec. Since these codes are
+ *              all for Fibre Channel this value will always be 2.
+ *          b = Specifies a subclass of the firmware where
+ *                  0 = FCP Initiator
+ *                  1 = FCP Target
+ *                  2 = LAN
+ *                  3 = MPI Message Layer
+ *                  4 = FC Link
+ *                  5 = Context Manager
+ *                  6 = Invalid Field Offset
+ *                  7 = State Change Info
+ *                  all others are reserved for future use
+ *          c = A specific value within the subclass.
+ *
+ * NOTE: Any new values should be added to the end of each subclass so that the
+ *       codes remain consistent across firmware releases.
+ */
+typedef enum _MpiIocLogInfoFc
+{
+    MPI_IOCLOGINFO_FC_INIT_BASE                     = 0x20000000,
+    MPI_IOCLOGINFO_FC_INIT_ERROR_OUT_OF_ORDER_FRAME = 0x20000001, /* received an out of order frame - unsupported */
+    MPI_IOCLOGINFO_FC_INIT_ERROR_BAD_START_OF_FRAME = 0x20000002, /* bad start of frame primative */
+    MPI_IOCLOGINFO_FC_INIT_ERROR_BAD_END_OF_FRAME   = 0x20000003, /* bad end of frame primative */
+    MPI_IOCLOGINFO_FC_INIT_ERROR_OVER_RUN           = 0x20000004, /* Receiver hardware detected overrun */
+    MPI_IOCLOGINFO_FC_INIT_ERROR_RX_OTHER           = 0x20000005, /* Other errors caught by IOC which require retries */
+    MPI_IOCLOGINFO_FC_INIT_ERROR_SUBPROC_DEAD       = 0x20000006, /* Main processor could not initialize sub-processor */
+
+    MPI_IOCLOGINFO_FC_TARGET_BASE                   = 0x21000000,
+    MPI_IOCLOGINFO_FC_TARGET_NO_PDISC               = 0x21000001, /* not sent because we are waiting for a PDISC from the initiator */
+    MPI_IOCLOGINFO_FC_TARGET_NO_LOGIN               = 0x21000002, /* not sent because we are not logged in to the remote node */
+    MPI_IOCLOGINFO_FC_TARGET_DOAR_KILLED_BY_LIP     = 0x21000003, /* Data Out, Auto Response, not sent due to a LIP */
+    MPI_IOCLOGINFO_FC_TARGET_DIAR_KILLED_BY_LIP     = 0x21000004, /* Data In, Auto Response, not sent due to a LIP */
+    MPI_IOCLOGINFO_FC_TARGET_DIAR_MISSING_DATA      = 0x21000005, /* Data In, Auto Response, missing data frames */
+    MPI_IOCLOGINFO_FC_TARGET_DONR_KILLED_BY_LIP     = 0x21000006, /* Data Out, No Response, not sent due to a LIP */
+    MPI_IOCLOGINFO_FC_TARGET_WRSP_KILLED_BY_LIP     = 0x21000007, /* Auto-response after a write not sent due to a LIP */
+    MPI_IOCLOGINFO_FC_TARGET_DINR_KILLED_BY_LIP     = 0x21000008, /* Data In, No Response, not completed due to a LIP */
+    MPI_IOCLOGINFO_FC_TARGET_DINR_MISSING_DATA      = 0x21000009, /* Data In, No Response, missing data frames */
+    MPI_IOCLOGINFO_FC_TARGET_MRSP_KILLED_BY_LIP     = 0x2100000a, /* Manual Response not sent due to a LIP */
+    MPI_IOCLOGINFO_FC_TARGET_NO_CLASS_3             = 0x2100000b, /* not sent because remote node does not support Class 3 */
+    MPI_IOCLOGINFO_FC_TARGET_LOGIN_NOT_VALID        = 0x2100000c, /* not sent because login to remote node not validated */
+    MPI_IOCLOGINFO_FC_TARGET_FROM_OUTBOUND          = 0x2100000e, /* cleared from the outbound after a logout */
+    MPI_IOCLOGINFO_FC_TARGET_WAITING_FOR_DATA_IN    = 0x2100000f, /* cleared waiting for data after a logout */
+
+    MPI_IOCLOGINFO_FC_LAN_BASE                      = 0x22000000,
+    MPI_IOCLOGINFO_FC_LAN_TRANS_SGL_MISSING         = 0x22000001, /* Transaction Context Sgl Missing */
+    MPI_IOCLOGINFO_FC_LAN_TRANS_WRONG_PLACE         = 0x22000002, /* Transaction Context found before an EOB */
+    MPI_IOCLOGINFO_FC_LAN_TRANS_RES_BITS_SET        = 0x22000003, /* Transaction Context value has reserved bits set */
+    MPI_IOCLOGINFO_FC_LAN_WRONG_SGL_FLAG            = 0x22000004, /* Invalid SGL Flags */
+
+    MPI_IOCLOGINFO_FC_MSG_BASE                      = 0x23000000,
+
+    MPI_IOCLOGINFO_FC_LINK_BASE                     = 0x24000000,
+    MPI_IOCLOGINFO_FC_LINK_LOOP_INIT_TIMEOUT        = 0x24000001, /* Loop initialization timed out */
+    MPI_IOCLOGINFO_FC_LINK_ALREADY_INITIALIZED      = 0x24000002, /* Another system controller already initialized the loop */
+    MPI_IOCLOGINFO_FC_LINK_LINK_NOT_ESTABLISHED     = 0x24000003, /* Not synchronized to signal or still negotiating (possible cable problem) */
+
+    MPI_IOCLOGINFO_FC_CTX_BASE                      = 0x25000000,
+
+    MPI_IOCLOGINFO_FC_INVALID_FIELD_BYTE_OFFSET     = 0x26000000, /* The lower 24 bits give the byte offset of the field in the request message that is invalid. */
+    MPI_IOCLOGINFO_FC_INVALID_FIELD_MAX_OFFSET      = 0x26ffffff,
+
+    MPI_IOCLOGINFO_FC_STATE_CHANGE                  = 0x27000000  /* The lower 24 bits give additional information concerning state change */
+
+} MpiIocLogInfoFc_t;