patch-2.4.21 linux-2.4.21/drivers/ide/pci/triflex.c

Next file: linux-2.4.21/drivers/ide/pci/triflex.h
Previous file: linux-2.4.21/drivers/ide/pci/slc90e66.h
Back to the patch index
Back to the overall index

diff -urN linux-2.4.20/drivers/ide/pci/triflex.c linux-2.4.21/drivers/ide/pci/triflex.c
@@ -0,0 +1,256 @@
+/*
+ * triflex.c
+ * 
+ * IDE Chipset driver for the Compaq TriFlex IDE controller.
+ * 
+ * Known to work with the Compaq Workstation 5x00 series.
+ *
+ * Copyright (C) 2002 Hewlett-Packard Development Group, L.P.
+ * Author: Torben Mathiasen <torben.mathiasen@hp.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA  02111-1307  USA
+ * 
+ * Loosely based on the piix & svwks drivers.
+ *
+ * Documentation:
+ *	Not publically available.
+ */
+
+#include <linux/config.h>
+#include <linux/types.h>
+#include <linux/module.h>
+#include <linux/kernel.h>
+#include <linux/delay.h>
+#include <linux/timer.h>
+#include <linux/mm.h>
+#include <linux/ioport.h>
+#include <linux/blkdev.h>
+#include <linux/hdreg.h>
+#include <linux/pci.h>
+#include <linux/ide.h>
+#include <linux/init.h>
+
+#include "ide_modes.h"
+#include "triflex.h"
+
+static struct pci_dev *triflex_dev;
+
+static int triflex_get_info(char *buf, char **addr, off_t offset, int count)
+{
+	char *p = buf;
+	int len;
+
+	struct pci_dev *dev	= triflex_dev;
+	unsigned long bibma = pci_resource_start(dev, 4);
+	u8  c0 = 0, c1 = 0;
+	u32 pri_timing, sec_timing;
+
+	p += sprintf(p, "\n                                Compaq Triflex Chipset\n");
+	
+	pci_read_config_dword(dev, 0x70, &pri_timing);
+	pci_read_config_dword(dev, 0x74, &sec_timing);
+
+	/*
+	 * at that point bibma+0x2 et bibma+0xa are byte registers
+	 * to investigate:
+	 */
+	c0 = inb((unsigned short)bibma + 0x02);
+	c1 = inb((unsigned short)bibma + 0x0a);
+
+	p += sprintf(p, "--------------- Primary Channel "
+			"---------------- Secondary Channel "
+			"-------------\n");
+	p += sprintf(p, "                %sabled "
+			"                        %sabled\n",
+			(c0&0x80) ? "dis" : " en",
+			(c1&0x80) ? "dis" : " en");
+	p += sprintf(p, "--------------- drive0 --------- drive1 "
+			"-------- drive0 ---------- drive1 ------\n");
+	p += sprintf(p, "DMA enabled:    %s              %s "
+			"            %s               %s\n",
+			(c0&0x20) ? "yes" : "no ",
+			(c0&0x40) ? "yes" : "no ",
+			(c1&0x20) ? "yes" : "no ",
+			(c1&0x40) ? "yes" : "no " );
+
+	p += sprintf(p, "DMA\n");
+	p += sprintf(p, "PIO\n");
+
+	len = (p - buf) - offset;
+	*addr = buf + offset;
+	
+	return len > count ? count : len;
+}
+
+static int triflex_tune_chipset(ide_drive_t *drive, u8 xferspeed)
+{
+	ide_hwif_t *hwif = HWIF(drive);
+	struct pci_dev *dev = hwif->pci_dev;
+	u8 channel_offset = hwif->channel ? 0x74 : 0x70;
+	u16 timing = 0;
+	u32 triflex_timings = 0;
+	u8 unit = (drive->select.b.unit & 0x01);
+	u8 speed = ide_rate_filter(0, xferspeed);
+	
+	pci_read_config_dword(dev, channel_offset, &triflex_timings);
+	
+	switch(speed) {
+		case XFER_MW_DMA_2:
+			timing = 0x0103; 
+			break;
+		case XFER_MW_DMA_1:
+			timing = 0x0203;
+			break;
+		case XFER_MW_DMA_0:
+			timing = 0x0808;
+			break;
+		case XFER_SW_DMA_2:
+		case XFER_SW_DMA_1:
+		case XFER_SW_DMA_0:
+			timing = 0x0f0f;
+			break;
+		case XFER_PIO_4:
+			timing = 0x0202;
+			break;
+		case XFER_PIO_3:
+			timing = 0x0204;
+			break;
+		case XFER_PIO_2:
+			timing = 0x0404;
+			break;
+		case XFER_PIO_1:
+			timing = 0x0508;
+			break;
+		case XFER_PIO_0:
+			timing = 0x0808;
+			break;
+		default:
+			return -1;
+	}
+
+	triflex_timings &= ~(0xFFFF << (16 * unit));
+	triflex_timings |= (timing << (16 * unit));
+	
+	pci_write_config_dword(dev, channel_offset, triflex_timings);
+	
+	return (ide_config_drive_speed(drive, speed));
+}
+
+static void triflex_tune_drive(ide_drive_t *drive, u8 pio)
+{
+	int use_pio = ide_get_best_pio_mode(drive, pio, 4, NULL);
+	(void) triflex_tune_chipset(drive, (XFER_PIO_0 + use_pio));
+}
+
+static int triflex_config_drive_for_dma(ide_drive_t *drive)
+{
+	int speed = ide_dma_speed(drive, 0); /* No ultra speeds */
+
+	if (!speed) { 
+		u8 pspeed = ide_get_best_pio_mode(drive, 255, 4, NULL);
+		speed = XFER_PIO_0 + pspeed;
+	}
+	
+	(void) triflex_tune_chipset(drive, speed);
+	 return ide_dma_enable(drive);
+}
+
+static int triflex_config_drive_xfer_rate(ide_drive_t *drive)
+{
+	ide_hwif_t *hwif	= HWIF(drive);
+	struct hd_driveid *id	= drive->id;
+	
+	if ((id->capability & 1) && drive->autodma) {
+		if (hwif->ide_dma_bad_drive(drive))
+			goto tune_pio;
+		if (id->field_valid & 2) {
+			if ((id->dma_mword & hwif->mwdma_mask) ||
+				(id->dma_1word & hwif->swdma_mask)) {
+				if (!triflex_config_drive_for_dma(drive))
+					goto tune_pio;
+			}
+		} else 
+			goto tune_pio;
+	} else {
+tune_pio:
+		hwif->tuneproc(drive, 255);
+		return hwif->ide_dma_off_quietly(drive);
+	}
+
+	return hwif->ide_dma_on(drive);
+}
+
+static void __init init_hwif_triflex(ide_hwif_t *hwif)
+{
+	hwif->tuneproc = &triflex_tune_drive;
+	hwif->speedproc = &triflex_tune_chipset;
+
+	hwif->atapi_dma  = 1;
+	hwif->mwdma_mask = 0x07;
+	hwif->swdma_mask = 0x07;
+	hwif->ide_dma_check = &triflex_config_drive_xfer_rate;
+	
+	if (!noautodma)
+		hwif->autodma = 1;
+	hwif->drives[0].autodma = hwif->autodma;
+	hwif->drives[1].autodma = hwif->autodma;
+}
+
+static unsigned int __init init_chipset_triflex(struct pci_dev *dev, 
+		const char *name) 
+{
+#ifdef CONFIG_PROC_FS
+	ide_pci_register_host_proc(&triflex_proc);
+#endif
+	return 0;	
+}
+
+static int __devinit triflex_init_one(struct pci_dev *dev, 
+		const struct pci_device_id *id)
+{
+	ide_pci_device_t *d = &triflex_devices[id->driver_data];
+	if (dev->device != d->device)
+		BUG();
+	
+	ide_setup_pci_device(dev, d);
+	triflex_dev = dev;
+	MOD_INC_USE_COUNT;
+	
+	return 0;
+}
+
+static struct pci_driver driver = {
+	.name		= "TRIFLEX IDE",
+	.id_table	= triflex_pci_tbl,
+	.probe		= triflex_init_one,
+};
+
+static int triflex_ide_init(void)
+{
+	return ide_pci_register_driver(&driver);
+}
+
+static void triflex_ide_exit(void)
+{
+	ide_pci_unregister_driver(&driver);
+}
+
+module_init(triflex_ide_init);
+module_exit(triflex_ide_exit);
+
+MODULE_AUTHOR("Torben Mathiasen");
+MODULE_DESCRIPTION("PCI driver module for Compaq Triflex IDE");
+MODULE_LICENSE("GPL");
+
+

FUNET's LINUX-ADM group, linux-adm@nic.funet.fi
TCL-scripts by Sam Shen (who was at: slshen@lbl.gov)