patch-2.1.99 linux/Documentation/specialix.txt

Next file: linux/Documentation/spinlocks.txt
Previous file: linux/Documentation/sound/ultrasound
Back to the patch index
Back to the overall index

diff -u --recursive --new-file v2.1.98/linux/Documentation/specialix.txt linux/Documentation/specialix.txt
@@ -44,10 +44,10 @@
 kernel sources?  And the manual of one of the boards in your computer?
 
 
-Adresses and interrupts
-=======================
+Addresses and interrupts
+========================
 
-Addres dip switch settings:
+Address dip switch settings:
 The dip switch sets bits 2-9 of the IO address. 
 
        9 8 7 6 5 4 3 2 
@@ -111,7 +111,7 @@
 fact is a divided by two mode). This is not enough to reach the rated
 115k2 on all ports at the same time. With this clock rate you can only
 do 37% of this rate. This means that at 115k2 on all ports you are
-going to loose characters (The chip cannot handle that many incoming
+going to lose characters (The chip cannot handle that many incoming
 bits at this clock rate.) (Yes, you read that correctly: there is a
 limit to the number of -=bits=- per second that the chip can handle.)
 
@@ -129,7 +129,7 @@
 
 The three characters that have the "^^^" under them have suffered a
 bit error in the highest bit. In conclusion: I've tested it, and found
-that it simply DOESN"T work for me. I also suspect that this is also
+that it simply DOESN'T work for me. I also suspect that this is also
 caused by the baud rate being just a little bit out of tune. 
 
 

FUNET's LINUX-ADM group, linux-adm@nic.funet.fi
TCL-scripts by Sam Shen, slshen@lbl.gov