patch-2.1.70 linux/include/linux/mcd.h

• Lines: 117
• Date: Wed Dec 31 16:00:00 1969
• Orig file: v2.1.69/linux/include/linux/mcd.h
• Orig date: Sun Nov 12 22:54:55 1995

diff -u --recursive --new-file v2.1.69/linux/include/linux/mcd.h linux/include/linux/mcd.h
@@ -1,116 +0,0 @@
-/*
- * Definitions for a Mitsumi CD-ROM interface
- *
- *	Copyright (C) 1992  Martin Harriss
- *
- *	martin@bdsi.com
- *
- *  This program is free software; you can redistribute it and/or modify
- *  it under the terms of the GNU General Public License as published by
- *  the Free Software Foundation; either version 2 of the License, or
- *  (at your option) any later version.
- *
- *  This program is distributed in the hope that it will be useful,
- *  but WITHOUT ANY WARRANTY; without even the implied warranty of
- *  MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
- *  GNU General Public License for more details.
- *
- *  You should have received a copy of the GNU General Public License
- *  along with this program; if not, write to the Free Software
- *  Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
- *
- */
-
-/* *** change this to set the I/O port address */
-#define MCD_BASE_ADDR	        0x300
-
-/* *** change this to set the interrupt number */
-#define MCD_INTR_NR     11
-
-/* *** make the following line uncommented, if you're sure,
- * *** all configuration is done */
-/* #define I_WAS_HERE */
-
-/* Increase this if you get lots of timeouts */
-#define MCD_STATUS_DELAY	200
-
-/* number of times to retry a command before giving up */
-#define MCD_RETRY_ATTEMPTS      5
-
-/* port access macro */
-#define MCDPORT(x)		(mcd_port + (x))
-
-/* status bits */
-
-#define MST_CMD_CHECK		0x01		/* command error */
-#define MST_BUSY		0x02		/* now playing */
-#define MST_READ_ERR		0x04		/* read error */
-#define MST_DSK_TYPE		0x08
-#define MST_SERVO_CHECK		0x10
-#define MST_DSK_CHG		0x20		/* disk removed or changed */
-#define MST_READY		0x40		/* disk in the drive */
-#define MST_DOOR_OPEN		0x80		/* door is open */
-
-/* flag bits */
-
-#define MFL_DATA		0x02		/* data available */
-#define MFL_STATUS		0x04		/* status available */
-
-/* commands */
-
-#define MCMD_GET_DISK_INFO	0x10		/* read info from disk */
-#define MCMD_GET_Q_CHANNEL	0x20		/* read info from q channel */
-#define MCMD_GET_STATUS		0x40
-#define MCMD_SET_MODE		0x50
-#define MCMD_SOFT_RESET		0x60
-#define MCMD_STOP		0x70		/* stop play */
-#define MCMD_CONFIG_DRIVE	0x90
-#define MCMD_SET_VOLUME		0xAE		/* set audio level */
-#define MCMD_PLAY_READ		0xC0		/* play or read data */
-#define MCMD_GET_VERSION  	0xDC
-#define MCMD_EJECT		0xF6            /* eject (FX drive) */
-
-/* borrowed from hd.c */
-
-#define READ_DATA(port, buf, nr) \
-insb(port, buf, nr)
-
-#define SET_TIMER(func, jifs) \
-	((timer_table[MCD_TIMER].expires = jiffies + jifs), \
-	(timer_table[MCD_TIMER].fn = func), \
-	(timer_active |= 1<<MCD_TIMER))
-
-#define CLEAR_TIMER		timer_active &= ~(1<<MCD_TIMER)
-
-#define MAX_TRACKS		104
-
-struct msf {
-	unsigned char	min;
-	unsigned char	sec;
-	unsigned char	frame;
-};
-
-struct mcd_Play_msf {
-	struct msf	start;
-	struct msf	end;
-};
-
-struct mcd_DiskInfo {
-	unsigned char	first;
-	unsigned char	last;
-	struct msf	diskLength;
-	struct msf	firstTrack;
-};
-
-struct mcd_Toc {
-	unsigned char	ctrl_addr;
-	unsigned char	track;
-	unsigned char	pointIndex;
-	struct msf	trackTime;
-	struct msf	diskTime;
-};
-
-#ifndef I_WAS_HERE
-#warning You have not edited mcd.h
-#warning Perhaps irq and i/o settings are wrong.
-#endif