patch-2.1.67 linux/drivers/net/README2.PLIP

Next file: linux/drivers/net/Space.c
Previous file: linux/drivers/net/README1.PLIP
Back to the patch index
Back to the overall index

diff -u --recursive --new-file v2.1.66/linux/drivers/net/README2.PLIP linux/drivers/net/README2.PLIP
@@ -1,78 +0,0 @@
-
-(2nd attempt. 1st bounced.)
-Hi again
-
-About my previous mail: I've looked into parallel.asm, and I'm
-rather confused. Looks like the code agrees with you, but not
-the protocol description preceding it?? I got to look more
-careful, but it wont be for a while (approx a week).
-
->From plip.c (v0.04):
-
->make one yourself.  The wiring is:
->    INIT        16 - 16         SLCTIN  17 - 17
->    GROUND      25 - 25
->    D0->ERROR   2 - 15          15 - 2
-
-I saw you removed 1 and 14 from the cable description, but not
-16 and 17. Why is that?
-
-Have been successful in getting parallel.com working (the Messy-Loss
-software). Using the pksend on the sender and pkall/pkwatch/whatnot
-gives me a hung receiver. (The cable works, I've tried unet11, a DOS
-cheap-net prog.)
-
-Using PLIP v0.03 and trying to ping the other end gives
-  88 timeout 88 timeout....(more) 2386 bogus packet size, dropped
-on the receiver, and on the sender lots of timeout, but of
-course I don't know how much is supposed to work.
-
-The following to something I wrote when I should have gone to bed a
-long time ago. Use it for whatever you like, or dump it in the bin. ;^)
-
-/Tommy
------
-Becker [& Co] proudly presents PLIP
-
-What is PLIP?
-=============
-
-PLIP is Parallel Line IP, that is, the transportation of IP packages
-over a parallel port. In the case of a PC, the obvious choice is the
-printer port.  PLIP is a non-standard, but [can use] uses the standard
-LapLink null-printer cable [can also work in turbo mode, with a PLIP
-cable]. [The protocol used to pack IP packages, is a simple one
-initiated by Crynwr.]
-
-Advantages of PLIP
-==================
-
-It's cheap, it's available everywhere, and it's easy.
-
-The PLIP cable is all that's needed to connect two Linux boxes, and it
-can be build for very bucks.
-
-Connecting two Linux boxes takes only a seconds decision and a few
-minutes work, no need to search for a [supported] netcard. This might
-even be especially important in the case of notebooks, where netcard
-are not easily available.
-
-Not requiring a netcard also means that apart from connecting the
-cables, everything else is software configuration [which in principle
-could be made very easy.]
-
-Disadvantages of PLIP
-=====================
-
-Doesn't work over a modem, like SLIP and PPP. Limited range, 15 m.
-Can only be used to connect three (?) Linux boxes. Doesn't connect to
-an exiting ethernet. Isn't standard (not even de facto standard, like
-SLIP).
-
-Performance
-==========
-
-PLIP easily outperforms ethernet cards....(ups, I was dreaming, but
-it *is* getting late. EOB)
-
-

FUNET's LINUX-ADM group, linux-adm@nic.funet.fi
TCL-scripts by Sam Shen, slshen@lbl.gov