From: Matt Domsch <Matt_Domsch@dell.com>
Some controller BIOSes have problems with the legacy int13 fn02 READ
SECTORS command. int13 fn42 EXTENDED READ is used in preference by most
boot loaders today, so lets use that. If EXTENDED READ fails or isn't
supported, fall back to READ SECTORS.
This hopefully resolves the three reports of BIOSes which would either
long-pause (30+ seconds) or hang completely on the legacy READ SECTORS
command.
This also adds CONFIG_EDD_SKIP_MBR to eliminate reading the MBR on each
BIOS-presented disk, in case there are further problems in this area.
Signed-off-by: Matt Domsch <Matt_Domsch@dell.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
---
25-akpm/arch/i386/boot/edd.S | 126 +++++++++++++++++++++++++++++++++------
25-akpm/drivers/firmware/Kconfig | 11 +++
25-akpm/include/linux/edd.h | 4 +
3 files changed, 123 insertions(+), 18 deletions(-)
diff -puN arch/i386/boot/edd.S~edd-use-extended-read-command-add-config_edd_skip_mbr arch/i386/boot/edd.S
--- 25/arch/i386/boot/edd.S~edd-use-extended-read-command-add-config_edd_skip_mbr Mon Oct 4 15:33:57 2004
+++ 25-akpm/arch/i386/boot/edd.S Mon Oct 4 15:33:57 2004
@@ -7,20 +7,66 @@
* and Andrew Wilks <Andrew_Wilks@dell.com> September 2003, June 2004
* legacy CHS retreival by Patrick J. LoPresti <patl@users.sourceforge.net>
* March 2004
+ * Use EXTENDED READ calls if possible, Matt Domsch, October 2004
*/
#include <linux/edd.h>
#if defined(CONFIG_EDD) || defined(CONFIG_EDD_MODULE)
-# Read the first sector of each BIOS disk device and store the 4-byte signature
-edd_mbr_sig_start:
movb $0, (EDD_MBR_SIG_NR_BUF) # zero value at EDD_MBR_SIG_NR_BUF
+#ifndef(CONFIG_EDD_SKIP_MBR)
+ xorl %edx, %edx
movb $0x80, %dl # from device 80
- movw $EDD_MBR_SIG_BUF, %bx # store buffer ptr in bx
-edd_mbr_sig_read:
- movl $0xFFFFFFFF, %eax
- movl %eax, (%bx) # assume failure
- pushw %bx
+
+edd_mbr_check_ext:
+ xorl %eax, %eax
+ xorl %ebx, %ebx
+ xorl %ecx, %ecx
+ movb $CHECKEXTENSIONSPRESENT, %ah # Function 41
+ movw $EDDMAGIC1, %bx # magic
+ pushw %dx # work around buggy BIOSes
+ stc # work around buggy BIOSes
+ int $0x13 # make the call
+ sti # work around buggy BIOSes
+ popw %dx
+ jc edd_start # no more BIOS devices
+ cmpw $EDDMAGIC2, %bx # is magic right?
+ jne edd_mbr_sig_next # nope, next...
+ testw $FIXEDDISKSUBSET, %cx # EXTENDED READ supported?
+ jz edd_mbr_read_sectors # nope, use READ SECTORS
+
+edd_mbr_extended_read:
+# Fill out the device address packet here, make the fn42 call
+ xorl %eax, %eax
+ xorl %ebx, %ebx
+ xorl %ecx, %ecx
+ subw $EDD_DEV_ADDR_PACKET_LEN, %sp # put packet on stack
+ pushw %si
+ movw %sp, %si
+ movl $0, (%si) # zero out packet
+ movl $0, 4(%si)
+ movl $0, 8(%si)
+ movl $0, 12(%si)
+ movb $EDD_DEV_ADDR_PACKET_LEN, (%si) # length of packet
+ movb $1, 2(%si) # move 1 sector
+ movw $EDDBUF, 4(%si) # into EDDBUF
+ movw %ds, 6(%si) # EDDBUF seg is ds
+ movb $EXTENDEDREAD, %ah
+ pushw %dx # work around buggy BIOSes
+ stc # work around buggy BIOSes
+ int $0x13
+ sti # work around buggy BIOSes
+ popw %dx
+ popw %si
+ addw $EDD_DEV_ADDR_PACKET_LEN, %sp # remove packet from stack
+ jnc edd_mbr_store_sig
+ # otherwise, fall through to the legacy read function
+
+edd_mbr_read_sectors:
+# Read the first sector of each BIOS disk device and store the 4-byte signature
+ xorl %eax, %eax
+ xorl %ebx, %ebx
+ xorl %ecx, %ecx
movb $READ_SECTORS, %ah
movb $1, %al # read 1 sector
movb $0, %dh # at head 0
@@ -28,23 +74,31 @@ edd_mbr_sig_read:
pushw %es
pushw %ds
popw %es
- movw $EDDBUF, %bx # disk's data goes into EDDBUF
- pushw %dx # work around buggy BIOSes
- stc # work around buggy BIOSes
+ movw $EDDBUF, %bx # disk's data goes into EDDBUF
+ pushw %dx # work around buggy BIOSes
+ stc # work around buggy BIOSes
int $0x13
- sti # work around buggy BIOSes
+ sti # work around buggy BIOSes
popw %dx
popw %es
- popw %bx
jc edd_mbr_sig_done # on failure, we're done.
+
+edd_mbr_store_sig:
+ xorl %ebx, %ebx # clear ebx
+ movb %dl, %bl # copy drive number to ebx
+ sub $0x80, %bl # subtract 80h from drive number
+ shlw $2, %bx # multiply by 4
+ addw $EDD_MBR_SIG_BUF, %bx # add to sig_buf
+ # bx now points to the right sig slot
movl (EDDBUF+EDD_MBR_SIG_OFFSET), %eax # read sig out of the MBR
movl %eax, (%bx) # store success
incb (EDD_MBR_SIG_NR_BUF) # note that we stored something
+edd_mbr_sig_next:
incb %dl # increment to next device
- addw $4, %bx # increment sig buffer ptr
cmpb $EDD_MBR_SIG_MAX, (EDD_MBR_SIG_NR_BUF) # Out of space?
- jb edd_mbr_sig_read # keep looping
+ jb edd_mbr_check_ext # keep looping
edd_mbr_sig_done:
+#endif
# Do the BIOS Enhanced Disk Drive calls
# This consists of two calls:
@@ -77,12 +131,35 @@ edd_start:
movw $EDDBUF+EDDEXTSIZE, %si # in ds:si, fn41 results
# kept just before that
movb $0, (EDDNR) # zero value at EDDNR
+ xorl %edx, %edx
movb $0x80, %dl # BIOS device 0x80
edd_check_ext:
+ pushw %di # zero out this edd_info block
+ pushw %es
+ movw %ds, %ax
+ movw %ax, %es
+ movw %si, %ax
+ subw $EDDEXTSIZE, %ax
+ movw %ax, %di
+ movl $EDDEXTSIZE+EDDPARMSIZE, %ecx
+ xorl %eax, %eax
+ cld
+ rep
+ stosb
+ popw %es
+ popw %di
+
+ xorl %eax, %eax
+ xorl %ebx, %ebx
+ xorl %ecx, %ecx
movb $CHECKEXTENSIONSPRESENT, %ah # Function 41
movw $EDDMAGIC1, %bx # magic
+ pushw %dx # work around buggy BIOSes
+ stc # work around buggy BIOSes
int $0x13 # make the call
+ sti # work around buggy BIOSes
+ popw %dx
jc edd_done # no more BIOS devices
cmpw $EDDMAGIC2, %bx # is magic right?
@@ -93,25 +170,38 @@ edd_check_ext:
movw %cx, %ds:-6(%si) # store extensions
incb (EDDNR) # note that we stored something
+ testw $GET_DEVICE_PARAMETERS_SUPPORTED, %cx
+ jz edd_get_legacy_chs # nope, skip fn48
+
edd_get_device_params:
+ xorl %eax, %eax
+ xorl %ebx, %ebx
+ xorl %ecx, %ecx
movw $EDDPARMSIZE, %ds:(%si) # put size
- movw $0x0, %ds:2(%si) # work around buggy BIOSes
movb $GETDEVICEPARAMETERS, %ah # Function 48
+ pushw %dx # work around buggy BIOSes
+ stc # work around buggy BIOSes
int $0x13 # make the call
+ sti # work around buggy BIOSes
+ popw %dx
# Don't check for fail return
# it doesn't matter.
edd_get_legacy_chs:
- xorw %ax, %ax
+ xorl %eax, %eax
+ xorl %ebx, %ebx
+ xorl %ecx, %ecx
movw %ax, %ds:-4(%si)
movw %ax, %ds:-2(%si)
- # Ralf Brown's Interrupt List says to set ES:DI to
+ # Ralf Brown's Interrupt List says to set ES:DI to
# 0000h:0000h "to guard against BIOS bugs"
- pushw %es
+ pushw %es
movw %ax, %es
movw %ax, %di
pushw %dx # legacy call clobbers %dl
movb $LEGACYGETDEVICEPARAMETERS, %ah # Function 08
+ stc # work around buggy BIOSes
int $0x13 # make the call
+ sti # work around buggy BIOSes
jc edd_legacy_done # failed
movb %cl, %al # Low 6 bits are max
andb $0x3F, %al # sector number
diff -puN drivers/firmware/Kconfig~edd-use-extended-read-command-add-config_edd_skip_mbr drivers/firmware/Kconfig
--- 25/drivers/firmware/Kconfig~edd-use-extended-read-command-add-config_edd_skip_mbr Mon Oct 4 15:33:57 2004
+++ 25-akpm/drivers/firmware/Kconfig Mon Oct 4 15:33:57 2004
@@ -18,6 +18,17 @@ config EDD
obscure configurations. Most disk controller BIOS vendors do
not yet implement this feature.
+config EDD_SKIP_MBR
+ bool "EDD: Skip Master Boot Record read"
+ depends on EDD
+ default n
+ help
+ Most controller BIOSs properly implement real-mode legacy
+ READ SECTORS commands. A few don't.
+
+ If your controller hangs during the kernel's real-mode
+ startup routine, say Y here.
+
config EFI_VARS
tristate "EFI Variable Support via sysfs"
depends on EFI
diff -puN include/linux/edd.h~edd-use-extended-read-command-add-config_edd_skip_mbr include/linux/edd.h
--- 25/include/linux/edd.h~edd-use-extended-read-command-add-config_edd_skip_mbr Mon Oct 4 15:33:57 2004
+++ 25-akpm/include/linux/edd.h Mon Oct 4 15:33:57 2004
@@ -37,14 +37,18 @@
#define EDDEXTSIZE 8 /* change these if you muck with the structures */
#define EDDPARMSIZE 74
#define CHECKEXTENSIONSPRESENT 0x41
+#define EXTENDEDREAD 0x42
#define GETDEVICEPARAMETERS 0x48
#define LEGACYGETDEVICEPARAMETERS 0x08
#define EDDMAGIC1 0x55AA
#define EDDMAGIC2 0xAA55
+#define FIXEDDISKSUBSET 0x0001
+#define GET_DEVICE_PARAMETERS_SUPPORTED 0x0007
#define READ_SECTORS 0x02 /* int13 AH=0x02 is READ_SECTORS command */
#define EDD_MBR_SIG_OFFSET 0x1B8 /* offset of signature in the MBR */
+#define EDD_DEV_ADDR_PACKET_LEN 0x10 /* for int13 fn42 */
#define EDD_MBR_SIG_BUF 0x290 /* addr in boot params */
#define EDD_MBR_SIG_MAX 16 /* max number of signatures to store */
#define EDD_MBR_SIG_NR_BUF 0x1ea /* addr of number of MBR signtaures at EDD_MBR_SIG_BUF
_