From: Chuck Ebbert <76306.1226@compuserve.com>
Without this patch I get the following on bootup with media inserted in a
USB powered Zip 250:
sda: Spinning up disk....<6>EXT3 FS on hde3, internal journal
Adding 524152k swap on /dev/hdg2. Priority:-1 extents:1
Adding 524152k swap on /dev/hde2. Priority:-2 extents:1
.<6>kjournald starting. Commit interval 5 seconds
(( --- Snip 17 lines of EXT3 mount messages --- ))
..<3>microcode: error! Bad data in microcode data file
microcode: Error in the microcode data
.....ready
Signed-off-by: Chuck Ebbert <76306.1226@compuserve.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
---
25-akpm/drivers/scsi/sd.c | 8 ++++----
1 files changed, 4 insertions(+), 4 deletions(-)
diff -puN drivers/scsi/sd.c~scsi-printk-fixes drivers/scsi/sd.c
--- 25/drivers/scsi/sd.c~scsi-printk-fixes Wed Jun 23 16:24:26 2004
+++ 25-akpm/drivers/scsi/sd.c Wed Jun 23 16:24:54 2004
@@ -949,7 +949,7 @@ sd_spinup_disk(struct scsi_disk *sdkp, c
} else if (SRpnt->sr_sense_buffer[2] == NOT_READY) {
unsigned long time1;
if (!spintime) {
- printk(KERN_NOTICE "%s: Spinning up disk...",
+ printk(KERN_NOTICE "%s: Spinning up disk...\n",
diskname);
cmd[0] = START_STOP;
cmd[1] = 1; /* Return immediately */
@@ -972,7 +972,6 @@ sd_spinup_disk(struct scsi_disk *sdkp, c
current->state = TASK_UNINTERRUPTIBLE;
time1 = schedule_timeout(time1);
} while(time1);
- printk(".");
} else {
/* we don't understand the sense code, so it's
* probably pointless to loop */
@@ -988,9 +987,10 @@ sd_spinup_disk(struct scsi_disk *sdkp, c
if (spintime) {
if (scsi_status_is_good(the_result))
- printk("ready\n");
+ printk(KERN_NOTICE "%s: Disk ready\n", diskname);
else
- printk("not responding...\n");
+ printk(KERN_NOTICE "%s: Disk not responding...\n",
+ diskname);
}
}
_