From: Pierre Ossman <drzeus-list@drzeus.cx>

Adds support for writing multiple sectors at once.  This allows
back-to-back transfers of sectors giving roughly double write throughput.

To be able to detect which sector is causing problems the system falls back
to single sector writes if a failure is detected.

Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Cc: Russell King <rmk@arm.linux.org.uk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
---

 drivers/mmc/Kconfig     |    9 ++++++
 drivers/mmc/mmc_block.c |   67 +++++++++++++++++++++++++++++++++++++++++++-----
 2 files changed, 70 insertions(+), 6 deletions(-)

diff -puN drivers/mmc/Kconfig~mmc-multi-sector-writes drivers/mmc/Kconfig
--- 25/drivers/mmc/Kconfig~mmc-multi-sector-writes	Wed Aug 17 15:52:31 2005
+++ 25-akpm/drivers/mmc/Kconfig	Wed Aug 17 15:52:31 2005
@@ -29,6 +29,15 @@ config MMC_BLOCK
 	  mount the filesystem. Almost everyone wishing MMC support
 	  should say Y or M here.
 
+config MMC_BULKTRANSFER
+	bool "Multi-block writes (EXPERIMENTAL)"
+	depends on MMC_BLOCK != n && EXPERIMENTAL
+	default n
+	help
+	  By default all writes are done one sector at a time. Enable
+	  this option to transfer as large blocks as the host supports.
+	  The transfer speed is in most cases doubled.
+
 config MMC_ARMMMCI
 	tristate "ARM AMBA Multimedia Card Interface support"
 	depends on ARM_AMBA && MMC
diff -puN drivers/mmc/mmc_block.c~mmc-multi-sector-writes drivers/mmc/mmc_block.c
--- 25/drivers/mmc/mmc_block.c~mmc-multi-sector-writes	Wed Aug 17 15:52:31 2005
+++ 25-akpm/drivers/mmc/mmc_block.c	Wed Aug 17 15:52:31 2005
@@ -171,9 +171,25 @@ static int mmc_blk_issue_rq(struct mmc_q
 	struct mmc_card *card = md->queue.card;
 	int ret;
 
+#ifdef CONFIG_MMC_BULKTRANSFER
+	int failsafe;
+#endif
+
 	if (mmc_card_claim_host(card))
 		goto cmd_err;
 
+#ifdef CONFIG_MMC_BULKTRANSFER
+	/*
+	 * We first try transfering multiple blocks. If this fails
+	 * we fall back to single block transfers.
+	 *
+	 * This gives us good performance when all is well and the
+	 * possibility to determine which sector fails when all
+	 * is not well.
+	 */
+	failsafe = 0;
+#endif
+
 	do {
 		struct mmc_blk_request brq;
 		struct mmc_command cmd;
@@ -192,14 +208,32 @@ static int mmc_blk_issue_rq(struct mmc_q
 		brq.stop.arg = 0;
 		brq.stop.flags = MMC_RSP_R1B;
 
+#ifdef CONFIG_MMC_BULKTRANSFER
+		/*
+		 * A multi-block transfer failed. Falling back to single
+		 * blocks.
+		 */
+		if (failsafe)
+			brq.data.blocks = 1;
+
+#else
+		/*
+		 * Writes are done one sector at a time.
+		 */
+		if (rq_data_dir(req) != READ)
+			brq.data.blocks = 1;
+#endif
+
+		ret = 1;
+
 		if (rq_data_dir(req) == READ) {
 			brq.cmd.opcode = brq.data.blocks > 1 ? MMC_READ_MULTIPLE_BLOCK : MMC_READ_SINGLE_BLOCK;
 			brq.data.flags |= MMC_DATA_READ;
 		} else {
-			brq.cmd.opcode = MMC_WRITE_BLOCK;
+			brq.cmd.opcode = brq.data.blocks > 1 ? MMC_WRITE_MULTIPLE_BLOCK :
+				MMC_WRITE_BLOCK;
 			brq.cmd.flags = MMC_RSP_R1B;
 			brq.data.flags |= MMC_DATA_WRITE;
-			brq.data.blocks = 1;
 		}
 		brq.mrq.stop = brq.data.blocks > 1 ? &brq.stop : NULL;
 
@@ -210,19 +244,19 @@ static int mmc_blk_issue_rq(struct mmc_q
 		if (brq.cmd.error) {
 			printk(KERN_ERR "%s: error %d sending read/write command\n",
 			       req->rq_disk->disk_name, brq.cmd.error);
-			goto cmd_err;
+			goto cmd_fail;
 		}
 
 		if (brq.data.error) {
 			printk(KERN_ERR "%s: error %d transferring data\n",
 			       req->rq_disk->disk_name, brq.data.error);
-			goto cmd_err;
+			goto cmd_fail;
 		}
 
 		if (brq.stop.error) {
 			printk(KERN_ERR "%s: error %d sending stop command\n",
 			       req->rq_disk->disk_name, brq.stop.error);
-			goto cmd_err;
+			goto cmd_fail;
 		}
 
 		do {
@@ -235,7 +269,7 @@ static int mmc_blk_issue_rq(struct mmc_q
 			if (err) {
 				printk(KERN_ERR "%s: error %d requesting status\n",
 				       req->rq_disk->disk_name, err);
-				goto cmd_err;
+				goto cmd_fail;
 			}
 		} while (!(cmd.resp[0] & R1_READY_FOR_DATA));
 
@@ -261,6 +295,27 @@ static int mmc_blk_issue_rq(struct mmc_q
 			end_that_request_last(req);
 		}
 		spin_unlock_irq(&md->lock);
+
+#ifdef CONFIG_MMC_BULKTRANSFER
+		/*
+		 * Go back to bulk mode if in failsafe mode.
+		 */
+		failsafe = 0;
+#endif
+
+		continue;
+
+ cmd_fail:
+
+#ifdef CONFIG_MMC_BULKTRANSFER
+		if (failsafe)
+	 		goto cmd_err;
+	 	else
+	 		failsafe = 1;
+#else
+ 		goto cmd_err;
+#endif
+
 	} while (ret);
 
 	mmc_card_release_host(card);
_